Figure 11-52 Securing Cables Into The Clips - Sun Microsystems Blade 1500 Service, Diagnostics, And Troubleshooting Manual

Routing clip
Power
supply
cables
Securing Cables Into the Clips
FIGURE 11-52
14. If you removed the old NVRAM prior to removing the old motherboard, install
the old NVRAM onto the new motherboard.
Refer to "Replacing the NVRAM" on page
15. Install the PCI cards, the new CPU fan and heat sink assembly, and the DIMMs.
Refer to:
"Installing a PCI Card" on page 11-38
■
"Installing the CPU Fan and Heat Sink Assembly" on page 11-18
■
"Installing DIMMs" on page 11-7
■
16. Reposition the chassis.
Refer to "Repositioning the Chassis" on page
■
17. If you removed them previously, install the rear fan and DIMM cooling duct.
Refer to:
"Installing the Rear Fan" on page 13-18
■
"Installing the DIMM Cooling Duct" on page 13-27
■
18. Install the chassis cross brace and PCI card support.
Refer to:
Reader cable clip
Chapter 11 Replacing the Motherboard and Associated Components
SCR0
Bezel cable clip
J24 SW0
FAN0 SYS
SPK0
J19 USB
J13 Audio
11-25.
15-1.
I/O cable clip
11-57