Figure 11-38 Opening The Pci Card Retainer - Sun Microsystems Blade 1500 Service, Diagnostics, And Troubleshooting Manual

FIGURE 11-38
5. Unlatch the PCI card retainer and lift it up.
See
FIGURE 11-38
6. Remove the chassis filler panel that corresponds to the PCI card slot you wish to
use.
See
FIGURE 11-35
7. Remove the new PCI card from its antistatic container.
Caution – Handle the PCI card along the outside edges. Do not handle the PCI card
along the contact edge.
8. Face the PCI card so that the PCI bracket aligns with the chassis rear panel slot
and the PCI card edge aligns with the motherboard PCI card slot.
9. Insert the PCI card into the PCI card slot.
See
FIGURE 11-39
Note – If you chose to keep the chassis in its upright position, use care that you do
not tip over the chassis.
11-40 Sun Blade 1500 Service, Diagnostics, and Troubleshooting Manual • December 2004
Screw
PCI card
retainer
Opening the PCI Card Retainer
.
. Remove an adjacent second filler panel if needed (SunPCI III Pro).
.