2. Remove the new power supply from its package.
3. Locate where the power supply is to be installed.
See
FIGURE 13-1
4. Align the power supply IEC-320 connector (power cord socket) and fan with the
chassis rear panel opening.
See
FIGURE 13-5
5. Position the power supply with the chassis power supply brackets.
6. Rotate the power supply down and into the chassis.
See
FIGURE 13-5
Power supply
fan
IEC-320
connector
Screws (3)
FIGURE 13-5
7. Using a No. 2 Phillips screwdriver, fasten the three screws that secure the power
supply to the chassis.
See
FIGURE 13-5
8. Feed the cables through the cable routing clips and close the cable routing clips.
See
FIGURE 13-6
13-6
Sun Blade 1500 Service, Diagnostics, and Troubleshooting Manual • December 2004
.
.
.
Power supply
Installing the Power Supply
.
Connectors
PS0, PS1, PS2