Replacing The I/O Board; Figure 10-18 Removing/Replacing The I/O Board - Sun Microsystems SPARCstation Voyager Service Manual

FIGURE 10-18

Replacing the I/O Board

1. Replace the I/O board into the unit.
See
FIGURE 10-18
2. Insert and tighten all screws on the back panel.
See
FIGURE 10-16
3. Tighten the screw on the I/O board.
See
FIGURE 10-17
4. Connect the DC power harness to the I/O board.
See
FIGURE 10-16
5. Connect the IR cable to the I/O board.
See
FIGURE 10-16
6. Connect the SCSI cable to the I/O board.
See
FIGURE 10-12
7. Replace the CPU board.
See Section "Replacing the CPU Board" on page 10-99.
8. Replace the hard disk drive.
See Section "Replacing the Hard Disk Drive" on page 9-94.
110 SPARCstation Voyager Service Manual • December 1994
Removing/Replacing the I/O Board
.
.
.
.
.
.
I/O board