Replacing A System Board - Sun Microsystems Ultra 1 Series Service Manual

Figure 10–4 Sliding the System Board Out of the Chassis
9. Place the system board on an antistatic surface. Handle the system board by
the back panel or by the edges only.
1. Remove SBus filler panel(s) from the replacement board so the rear panel of
the replacement board and the defective board look the same.
a. Squeeze the filler panel bottom locking tabs to unhook them from the back
panel.
See Figure 10–5.
b. Pull the filler panel away from the back panel.
System Board and Component Replacement
85