Replacing The Creator Board - Sun Microsystems Ultra 1 Series Upgrade Manual

Replacing the Creator Board

!
If the old Sun Ultra 1 Series system contained a Creator board, install it in the
new system now.
1. Verify that both card retainers are pushed back (Figure 3-12).
2. At an angle, lower the Creator board into the chassis over the UPA socket.
3. Hook the Creator board backplate under the chassis back panel tabs.
Ensure that the backplate is visible through the back panel slot.
4. Carefully press both corners of the Creator board evenly to seat the
Creator board connector into the UPA socket (Figure 3-13).
Caution – Avoid applying force to one end or one side of the Creator board or
the connector pins may be damaged.
5. Push the card retainer onto the board (Figure 3-14).
6. Replace the two screws and washers securing the Creator board to the
back panel.
Back panel tab (2)
Backplate
Figure 3-12 Replacing the Creator Board
System Board and Component Replacement
Creator
3
UPA socket
Card retainer (2)
33