Channel-Related Diagnostics - Error Types - Siemens SIMATIC ET 200S Manual

Diagnostics

3.2 Channel-related diagnostics - error types

3.2 Channel-related diagnostics - error types
Analog input module error types
Table 3-1
31
D
22
D
16
D
9
D
8
D
7
D
6
D
16
Error types
Error type
11111: Channel The firmware is being updated.
temporarily Channel 0 applies to the entire
unavailable module. The module does not
perform any measurements
during this time.
10110: Hardware A hardware interrupt was not
interrupt lost recognized.
10000: Parameter Module cannot utilize the
assignment error parameters for the channel:
Inserted module does not
match the configuration.
Incorrect parameter
assignment.
01001: Error Internal module error
(diagnostic message at
channel 0 applies to the entire
module)
01000: Low limit Value is below the underrange. Correct the module/actuator
exceeded
00111: High limit Value is above the overrange.
exceeded
00110: Line to the encoder is
Open circuit interrupted.
Meaning
2AI I 2WIRE HS analog electronic module (6ES7134-4GB52-0AB0)
Remedy
--
Correction or coordination of
the program, process, module
Correct the configuration (align
actual and preset configuration).
Correct the parameter
assignment (wire break
diagnostics assigned only for
the allowed measuring ranges).
Replace the module.
tuning.
Correct the module/actuator
tuning.
Correct the process wiring.
Manual, 01/2008, A5E01001734-02