Table of Contents
Advertisement
M12S SUPER
2.4GHZ FH4T RADIO CONTROL SYSTEM USER'S GUIDE
LOG SETUP MENU { DISPLAY ONLY TELEMETRY OPTIONS }
Steering and Throttle Output Data Display Adjustments
The Steering Point and Throttle Point functions allow you to calibrate the TELEMETRY screen ALL page Steering and Throttle
Output Data Displays, so the Output Data displayed matches your paired transmitter's Steering Wheel and Throttle Trigger
movement.
If you don't use the Steering Point and Throttle Point functions to calibrate the Steering and Throttle Output Data Displays,
incorrect Output Data will be displayed. These steps should be performed
after placing the M12S Super in Receiver Mode and Binding it to your other
transmitter.
Calibrating the Steering Output Data Display:
1) With the transmitter turned OFF, press and HOLD the DISPLAY key to turn only
the Display ON.
2) From within the SYSTEM menu, scroll UP or DOWN to highlight the LOG SETUP
menu.
3) Press the ENTER key to open the LOG SETUP menu, then scroll UP or DOWN
to highlight the ST POINT menu.
4) Press the ENTER key. The ST POINT menu will be displayed and NEUTRAL
POINT > 127 will be highlighted.
5) With your other transmitter turned ON and paired with the M12S Super, do the
following:
A) Center the other transmitter's Steering Wheel, then press the ENTER key
on the M12S Super.
B) Scroll DOWN to highlight LEFT END > 212. Rotate and HOLD the other
transmitter's Steering Wheel all the way to the LEFT, then press the ENTER
key on the M12S Super.
C) Scroll DOWN to highlight RIGHT END > 42. Rotate and HOLD the other
transmitter's Steering Wheel all the way to the RIGHT, then press the
ENTER key on the M12S Super.
The values displayed in the ST POINT fields don't represent actual
Steering Wheel movement and may vary. Steering Wheel movement
is displayed as a percentage below the ST POINT fields.
Calibrating the Throttle Output Data Display:
1) Without turning the transmitter ON, press and HOLD the DISPLAY key to turn
only the Display ON.
2) From within the SYSTEM menu, scroll UP or DOWN to highlight the LOG SETUP
menu.
3) Press the ENTER key to open the LOG SETUP menu, then scroll UP or DOWN
to highlight the TH POINT menu.
Telemetry System with Sanwa Synchronized Link Support
T
SYSTEM
65
Advertisement
Table of Contents
