Table of Contents
Advertisement
M12S SUPER
2.4GHZ FH4T RADIO CONTROL SYSTEM USER'S GUIDE
SUB TRIM MENU { SERVO CENTERING }
Changing the Servo Sub-Trim Values, Continued:
2) From within the SETUP menu, scroll UP or DOWN to highlight the SUB TRIM
menu.
3) Press the ENTER key to open the SUB TRIM menu. The cursor will default to
ST > 0.
4) Scroll UP or DOWN to highlight the desired Sub-Trim value you would like to
change.
5) Press the ENTER key, then scroll UP or DOWN to Increase or Decrease the
Sub-Trim value only enough to center the servo horn.
6) Press the ENTER key, then repeat steps 4 and 5 to change any other desired
Sub-Trim values.
ST setting range is R150 to L150, TH setting range is H150 to B150, AUX1 setting range is H150 to L150 and AUX2 setting
range is H150 to L150. The default setting for all channels is 0.
IMPORTANT: Changing the Sub-Trim values will alter the servo's End Points. After changing the Sub-Trim values, use the
End Point Adjustment function to Reset the servo End Point Adjustment Percentage Values. For more information, see the
EPA Menu section on pages 72 and 73.
REV MENU { SERVO REVERSING }
The Servo Reversing function allows you to electronically switch the direction of servo travel. For example, if you rotate the Steering
Wheel to the Right, and the Steering servo moves to the Left, you can use the Servo Reversing function to make the Steering servo
move to the Left. The Servo Reversing function is available for all four channels.
When you change the direction of servo travel, the servo horn may no longer be centered. If this occurs, use the Servo
Sub-Trim function to center the servo horn. For more information, see the
Changing the Servo Sub-Trim Values section on pages 74 and 75.
Changing the Servo Reversing Values:
1) From within the SETUP menu, scroll UP or DOWN to highlight the REV menu.
2) Press the ENTER key to open the REV menu. The cursor will default to ST > NOR.
Telemetry System with Sanwa Synchronized Link Support
T
SETUP
SETUP
75
Advertisement
Table of Contents
