Table of Contents
Advertisement
M12S SUPER
2.4GHZ FH4T RADIO CONTROL SYSTEM USER'S GUIDE
SPEED MENU { SERVO SPEED }
The Servo Speed function allows you to slow the transit speed of the Steering, Throttle, Auxiliary 1 and Auxiliary 2 channels. When
driving your model, proper Steering and Throttle control are vital. For example, lowering the transit speed of the Steering servo
can help to limit excessive Steering, which will enable you to achieve smoother cornering. In addition, lowering the transit speed
of the Throttle servo High Side can help to ensure smooth Throttle control. This function can be used in conjunction with the
Exponential, ARC or Point Curve functions to increase the effect.
Forward
Return to Neutral
L
Point
N
The Servo Speed function can be programmed for each of the four channels, however, depending on the current Car Type,
not all channels may be able to be selected. For example, if your current Car Type features Front and Rear Steering and
Front and Rear Motors (such as Car Type X), only ST and TH channel options will be programmable, however, both Front and Rear
channels will be programmed with the same Programming Values.
Servo Speed Programming Values can be changed while you're driving by Assigning these functions to a Trim Switch, the
Auxiliary Dial or the Auxiliary Lever. For more information, see the ASSIGN
Menu section on pages 37 through 46.
Choosing the Channel:
1) From within the RACING menu, scroll UP or DOWN to highlight the SPEED
menu.
2) Press the ENTER key to open the SPEED menu. The < ST > channel will be
selected.
3) Press the SELECT switch RIGHT or LEFT to choose the desired channel you
would like to program the Servo Speed function for.
When the Throttle channel is selected, you are able to adjust Servo Speed function Programming Values separately for
both the Throttle High Side (H) and the Throttle Brake Side (B). Scroll UP or DOWN to view High Side (H) and Brake
Side (B) program options.
Changing the Servo Speed Forward Value:
1) From within the SPEED menu, scroll UP or DOWN to highlight FORWARD > 0.
2) Press the ENTER key, then scroll UP or DOWN to choose the desired Servo
Speed Forward value. When 0 is selected, the servo will travel at its normal
speed in the Forward direction. When a Negative value is selected, the servo
transit speed will slow down in the Forward direction.
FORWARD setting range is 0 to -100. The default setting is 0 (Normal Speed).
Changing the Servo Speed Return Value:
1) From within the SPEED menu, scroll UP or DOWN to highlight RETURN > 0.
2) Press the ENTER key, then scroll UP or DOWN to choose the desired Servo
Speed Return value. When 0 is selected, the servo will travel at its normal
speed in the Return to Neutral direction. When a Negative value is selected,
the servo transit speed will slow down in the Return to Neutral direction.
RETURN setting range is 0 to -100. The default setting is 0 (Normal Speed).
Telemetry System with Sanwa Synchronized Link Support
Forward
Servo transit speed can be slowed in the Forward and the Return to
Return to Neutral
Neutral directions independently. In addition, you are able to program
a Point on either side of servo travel, then define whether the servo transit
speed is slowed down either Outside or Inside those two Points.
R
Point
T
RACING
95
Advertisement
Table of Contents
