Table of Contents
Advertisement
M12S SUPER
2.4GHZ FH4T RADIO CONTROL SYSTEM USER'S GUIDE
ASSIGN MENU { SWITCH, DIAL, LEVER AND TELEMETRY FUNCTION ASSIGNMENTS }
Changing the High and Low Tweak Values, Continued:
1) From within the LEVER menu, scroll UP or DOWN to highlight LEVER
[TWEAK (H)] > +100.
2) Press the ENTER key, then scroll UP or DOWN to choose the desired High
Side Tweak value. Increasing the Tweak value will Increase travel in the
High Side direction and Decreasing the Tweak value will Decrease travel in
the High Side direction. Using a Negative value will change the direction of travel.
TWEAK (H) setting range is -100 to +100. The default setting is +100.
3) Scroll DOWN to highlight LEVER [TWEAK (L)] > -100.
4) Press the ENTER key, then scroll UP or DOWN to choose the desired Low Side
Tweak value. Decreasing the Tweak value will Increase travel in the Low
Side direction and Increasing the Tweak value will Decrease travel in the
Low Side direction. Using a Positive value will change the direction of travel.
TWEAK (L) setting range is -100 to +100. The default setting is -100.
Telemetry Function Assignments
The M12S Super allows the use of a remote external device (available separately) to control many transmitter functions. This allows
a driver helper or a pit crew member to remotely control transmitter functions, allowing you to concentrate more on driving. The
Telemetry Assign function allows you to program the transmitter to suit the programmed function and the specific requirements
of your external device, whether it features a push-button switch, a trim switch or dial, or a lever. Functions such as the Lap
Timer, Throttle Hold and much more can now be controlled remotely by a 3rd party.
External devices available separately. For more information about availability, contact your local Airtronics or Sanwa retailer.
The M12S Super's Telemetry function must be turned ON, you must be using an Airtronics or Sanwa 2.4GHz FH4T receiver
and the external device must be paired for this function to work. For detailed information about connecting and using the
external device itself, refer to the User's Guide included with your external device.
Changing the Telemetry Value:
The Telemetry value allows you program the M12S Super's Telemetry Assign
function to match the type of control on the connected external device. For
example, if the external device you have features a push-button switch, choose
SW, or if the external device features a lever, choose LEVER.
1) From within the SYSTEM menu, scroll UP or DOWN to highlight the ASSIGN
menu.
2) Press the ENTER key to open the ASSIGN menu, then scroll UP or DOWN to
highlight the TELEMETRY menu.
3) Press the ENTER key to open the TELEMETRY menu. TELEMETRY > SW will be
highlighted.
4) Press the ENTER key, then scroll UP or DOWN to choose the Telemetry value
that matches the type of control on the connected external device. Choose from
SW (push-button switch), TRIM (trim switch or dial) or LEVER (lever).
TELEMETRY setting range is SW, TRIM and LEVER. The default setting is SW.
Telemetry System with Sanwa Synchronized Link Support
T
SYSTEM
43
Advertisement
Table of Contents
