Table of Contents
Advertisement
M12S SUPER
2.4GHZ FH4T RADIO CONTROL SYSTEM USER'S GUIDE
LOG SETUP MENU { TELEMETRY DISPLAY AND LOGGING OPTIONS }
Calibrating the RPM Sensor - Changing the 10Count Distance Value, Continued:
1) With your transmitter and receiver turned ON, and with an Active Telemetry connection, place your model on the ground.
2) Measuring in inches (or centimeters if using KM/H) from where you set your model on the ground, slowly push your model
and measure the distance covered to complete 10 full revolutions of the RPM sensor (the Bind LED on your receiver will flash
10 times, indicating 10 full revolutions).
3) From within the RPM menu and with UNIT > MPH or UNIT > KM/H selected,
scroll UP or DOWN to highlight 10COUNT DIST > 12.0 or 10COUNT DIST > 30,
depending on the UNIT > value selected previously.
4) Press the ENTER key, then scroll UP or DOWN to change the 10Count Distance
value to match the measurement obtained in step 2 above. For example, if
your model traveled 2 feet (61cm) to complete 10 full revolutions, enter 24.0
(for MPH) or 61 (for KM/H).
10COUNT DIST setting range is 0.5 to 118.0 for MPH and 1 to 300 for KM/H.
The default setting is 12.0 for MPH and 30 for KH/H.
IMPORTANT: Changing the 10Count Distance value will change the Maximum Scale value. After calibration, you should
reset the Maximum Scale value back to the value you chose previously.
Battery Low Voltage Telemetry Data Display and Alert Alarm Options
The VOLT menu allows you to change the way receiver or motor battery Voltage information is displayed on the TELEMETRY screen
ALL and VOLT pages and when the receiver Low Voltage Alert alarm sounds. For example, the Maximum Voltage value can be
adjusted to calibrate the VOLT Indicator on the TELEMETRY screen ALL page. In addition, you can adjust the Voltage value that
the receiver Low Voltage Alert alarm will sound at to match the type of receiver or motor battery you're using.
Changing the Maximum Voltage Value:
1) From within the SYSTEM menu, scroll UP or DOWN to highlight the LOG SETUP
menu.
2) Press the ENTER key to open the LOG SETUP menu, then scroll UP or DOWN
to highlight the VOLT menu.
3) Press the ENTER key to open the VOLT menu. MAX VOLT > 9.0V will be
highlighted.
Telemetry System with Sanwa Synchronized Link Support
T
SYSTEM
59
Advertisement
Table of Contents
