Table of Contents
Advertisement
M12S SUPER
2.4GHZ FH4T RADIO CONTROL SYSTEM USER'S GUIDE
DOWN MENU { COUNTDOWN TIMER }
Setting the Finish Time, Continued:
2) Press the ENTER key to open the DOWN menu. FIN TIME > 60' will be highlighted.
3) Scroll UP or DOWN to highlight the desired Finish Time value you would like
to change, either 00' (Minutes) , 00" (Seconds) or 00 (1/100th Seconds).
4) Press the ENTER key, then scroll UP or DOWN to choose the desired Finish
Time value.
5) Press the ENTER key again, then repeat steps 3 and 4 to change any other desired Finish Time values.
FIN TIME setting range is 00:00:00 to 99:59:90. The default setting is 60:00:00.
Choosing the Optional Throttle Trigger Start:
The Throttle Trigger can be used to Start the Countdown Timer after the Countdown Timer as been placed in Standby by pressing
the Push-Button Switch it's Assigned to. This is much more convenient and accurate than pressing the Push-Button Switch again
to Start the Countdown Timer when you're trying to start your race.
1) From within the DOWN menu, scroll UP or DOWN to highlight START
TRIGGER > OFF.
2) Press the ENTER key, then scroll UP or DOWN to choose the desired Start
Trigger value, either ON or OFF.
START TRIGGER setting range is OFF and ON. The default setting is OFF.
Starting the Countdown Timer:
To control the Countdown Timer, it must first be Assigned to a Push-Button Switch. If desired, the Countdown Timer can be
Started and Stopped by Assigning it to its own Push-Button Switch, or it can be Started and Stopped along with the Lap Timer by
Assigning it to the same Push-Button Switch as the Lap Timer. Regardless of what you decide, follow the step below to control the
Countdown Timer.
1) Press and HOLD the Push-Button Switch you've Assigned the Countdown Timer to for 3 seconds. An audible Double-Tone
will sound and DOWN [ STANDBY ] will be displayed momentarily in a pop-up window, indicating the Countdown Timer is
in Standby. To Start the Countdown Timer, press the Push-Button Switch a second time or pull the Throttle Trigger if you've
Enabled the Start Trigger function. An audible Double-Tone will sound and the Countdown Timer will start counting Down. An
audible tone will sound in 1 second intervals 5 seconds before the Countdown Timer reaches zero. When zero is reached, a
long audible tone will sound and the Countdown Timer will begin counting Up.
If the Countdown Timer is Assigned to the same Push-Button Switch as the Lap Timer and the Lap Timer is Assigned to
Switch Function 1, LAP will flash and Lap Time information will be displayed in a pop-up window, but the Countdown
Timer will still run in the background.
If you program the Lap Counter to Start when you pull the Throttle Trigger, the Countdown Timer will not Start unless
you also program it to Start when you pull the Throttle Trigger, and vice-versa. For the Throttle Trigger to Start both Timers,
both the Lap Timer and the Countdown Timer Start Trigger function must be programmed to ON.
Stopping the Countdown Timer:
1) To stop the Countdown Timer, press and HOLD the Push-Button Switch you've Assigned it to for 3 seconds. An audible
Double-Tone will sound indicating the Countdown Timer is stopped. Press and HOLD the Push-Button Switch again for 3
seconds to reset the Countdown Timer to the programmed Finish Time and place it in Standby again.
86
Telemetry System with Sanwa Synchronized Link Support
SETUP
Advertisement
Table of Contents
