Changing The Boot Options - Sanwa M12S SUPER User Manual

M12S SUPER
2.4GHZ FH4T RADIO CONTROL SYSTEM USER'S GUIDE
INFORMATION MENU { FIRMWARE VERSION, BOOT SCREEN, AND BASIC MODE }
Resetting the On-Time, Continued:
2) Press the ENTER key to open the INFORMATION menu. ON TIME > 00:00 (or
the actual Cumulative On-Time) will be highlighted and the current Firmware
version will be displayed.
3) Press and HOLD the ENTER key to Reset the ON TIME to 00:00.

Changing the Boot Options:

The Boot function allows you to change the default start-up behavior of the transmitter when it's turned ON.
1) From within the INFORMATION menu, scroll UP or DOWN to highlight
BOOT > DEMO.
2) Press the ENTER key, then scroll UP or DOWN to choose the desired Boot
value. When DEMO is selected, the Logo will be displayed during the start-up
process, then default to the STATUS screen. When RESUME is selected,
the transmitter will display the last Programming Menu you were in when the
transmitter was turned OFF. When TOP is selected, the transmitter will default
to the STATUS screen when turned ON.
BOOT setting range is DEMO, RESUME and TOP. The default setting is DEMO.
Turning BASIC Mode ON and OFF:
The M12S Super features a BASIC Mode that simplifies transmitter use. The accompanying BASIC menu contains some of the
more common, general-use Programming Menus that a user will require for basic programming.
When BASIC Mode is turned ON, not only are these various Programming Menus in one easy place to find them, so you don't
need to spend time finding them in one of the other four menus, but it also removes the TELEMETRY and ASSIGN screens to
simplify transmitter use.
1) From within the INFORMATION menu, scroll UP or DOWN to highlight
BASIC > OFF.
2) Press the ENTER key, then scroll UP or DOWN to select the desired option,
either ON or OFF. When ON is selected, BASIC Mode will be turned ON and
when OFF is selected, BASIC Mode will be turned OFF.
BASIC setting range is ON and OFF. The default setting is ON.
Changing the Programming Cursor Scroll Direction:
The direction the Push-Button Rotary Dial moves the Programming Cursor can be changed. For example, you might want to
reverse the direction the Programming Cursor moves relative to the Push-Button Rotary Dial is you've switched the transmitter to
the left-handed driving position.
1) From within the INFORMATION menu, scroll UP or DOWN to highlight
KEY > NOR.
2) Press the ENTER key, then scroll UP or DOWN to select the desired option.
Choose from either NOR (Normal) or REV (Reverse).
KEY setting range is NOR and REV. The default setting is NOR.
72
Telemetry System with Sanwa Synchronized Link Support
SYSTEM