Table of Contents
Advertisement
M12S SUPER
2.4GHZ FH4T RADIO CONTROL SYSTEM USER'S GUIDE
TRIM TYPE MENU { SERVO TRIM TYPE }
The Trim Type function allows you choose the way servo Trim and servo End Point Adjustments interact with each other. When
you apply Trim to a servo, the Neutral Point of the servo shifts toward the High Side or the Low Side. When you do this, the servo
travels less in one direction and more in the other direction because the servo End Points are stationary. In order to balance the
servo travel, you would need to manually readjust the servo End Points. Using the Trim Type function allows you to make the servo
End Points shift toward the High Side or the Low Side when you apply Trim. This maintains balanced servo travel without the need
to manually readjust the servo End Points.
The Trim Type function does not effect servo Sub-Trim. It only effects servo Trim that's input using the Trim Switches, Auxiliary
Dial or Auxiliary Lever. Servo Sub-Trim, which is different, always uses Parallel Trim.
Two Trim Types are available:
CENTER - When selected, servo End Points are stationary. In order to balance servo travel, you would need to
manually readjust the servo End Points, if desired.
PARALLEL - When selected, servo End Points shift toward the High Side or the Low Side automatically
when you apply Trim. This maintains balanced servo travel without the need to manually readjust the
servo End Points, however, this could result your model's control linkages binding in one direction or
the other.
Changing the Trim Type:
1) From within the SYSTEM menu, scroll UP or DOWN to highlight the TRIM TYPE
menu.
2) Press the ENTER key to open the TRIM TYPE menu. ST > CENT will be
highlighted.
3) Scroll UP or DOWN to highlight the desired channel you would like to change
the Trim Type value for. Choose from either ST (Steering), TH (Throttle),
AUX1 (Auxiliary 1) or AUX2 (Auxiliary 2).
4) Press the ENTER key, then scroll UP or DOWN to choose the desired Trim
Type value for that channel.
5) Press the ENTER key, then repeat steps 3 and 4 to change the Trim Type value for any other desired channels.
TRIM TYPE setting range is CENT and PARA. The default setting for all channels is CENT.
TH TYPE MENU { THROTTLE BIAS RATIO }
The Throttle Type function allows you to change the ratio between Throttle High Side servo travel and Throttle Brake Side servo
travel. In the default configuration, the Throttle Type is set to F70:B30. This Throttle Type shifts the Throttle Neutral Point toward the
Brake Side, resulting in more servo travel toward the High Side and less servo travel toward the Brake Side.
Some users may prefer the ratio between Throttle High Side servo travel and Throttle Brake Side servo travel to be balanced
(F50:B50) so that servo travel is equal. The F70:B30 Throttle Type is most common for general-use and racing, while the F50:B50
Throttle Type is most common for Rock Crawling.
Telemetry System with Sanwa Synchronized Link Support
T
SYSTEM
SYSTEM
51
Advertisement
Table of Contents
