Table of Contents
Advertisement
M12S SUPER
2.4GHZ FH4T RADIO CONTROL SYSTEM USER'S GUIDE
SYSTEM MENU OVERVIEW
To access the various SYSTEM menu Programming Menus, turn the transmitter
ON, press the SELECT switch to highlight the SYSTEM menu, then press the
ENTER key to open the SYSTEM menu.
Scroll UP or DOWN to highlight the desired Programming Menu, then press the
ENTER key to open that menu.
BASIC Mode must be turned OFF to access the SYSTEM menu. For more information, see the Turning BASIC Mode ON
and OFF section on the previous page. In addition, depending on the Car Type chosen, some Function Programming Value
Names may differ from those shown in this section.
The following Programming Menus are available within the SYSTEM menu:
MENU
TYPE
Choose Car Type Templates From Normal to Crawler
MODEL
Model Select, Model Name, Model Copy, Model Clear, Model Sort and Model Templates
DMS
Direct Model Select - Use to Quickly Select Your Favorite Models
BIND
Bind, Choose Modulation Type, Safety Link Number and Channel Response Mode
SERVO
Use the Servo Monitor to View Servo Travel Digitally
ASSIGN
Assign Functions to the Switches, Rotary Dial, Auxiliary Lever and Telemetry
BUZZER
Turn Audible Key Tones and Alarms ON and OFF and Control Their Pitch and Volume
VIBRATOR
Turn Vibrating Alerts and Alarms ON and OFF
LCD
Adjust the Contrast, Brightness and Display Mode of the LCD Screen
AUX TYPE
Choose the Operating Mode of the Two Auxiliary Channels
TRIM TYPE
Choose the Desired Servo Trim Type - Either Parallel or Centered
TH TYPE
Choose the Desired Throttle Bias Type
CALIBRATION
Calibrate Steering, Throttle and Auxiliary Lever Controls
BATT
Specify Transmitter Battery Low Voltage Alert and Limit Alarms
LOG SETUP
Program TELEMETRY Screen and Telemetry Recording Options
USER NAME
Change the Name Displayed Above the M12S Super Logo on the STATUS Screen
PC LINK
Save Telemetry Logs, Save and Load Model Programming and Update Firmware
INFORMATION
View Firmware Version, Change Boot Screen, Turn BASIC Mode ON and OFF, and More
TYPE MENU { CAR TYPE TEMPLATES }
The Type function allows you to quickly set up the transmitter's Mixing options based on the type of model you're driving.
Common templates for Car or Truck and Crawler Car Types are provided. For example, if your Crawler features separate
Front and Rear Steering servos, choosing one of the Crawler Car Types will automatically program the transmitter for Four
Wheel Steering. The TYPE menu will also display what receiver channels to plug the servos into since this will vary depending on
the Car Type chosen. This takes the guess-work out of setting up your model.
WARNING: TYPE menu selections are designed to be used when setting up a new model and should be done prior to
making any programming changes to your model. When the Type function is used to change the Car Type, all Programming
Data (including custom Programming Data) for the current model will be RESET!
Choosing a Car Type:
1) From within the SYSTEM menu, scroll UP or DOWN to highlight the TYPE
menu.
Telemetry System with Sanwa Synchronized Link Support
MENU DESCRIPTION
T
SYSTEM
PAGE #
PG. 27
PG. 28
PG. 34
PG. 34
PG. 36
PG. 37
PG. 46
PG. 47
PG. 48
PG. 50
PG. 51
PG. 51
PG. 52
PG. 54
PG. 56
PG. 66
PG. 67
PG. 71
SYSTEM
27
Advertisement
Table of Contents
