Changing The Switch Mode; Trim Switch Function Assignments - Sanwa M12S SUPER User Manual

M12S SUPER
2.4GHZ FH4T RADIO CONTROL SYSTEM USER'S GUIDE
ASSIGN MENU { SWITCH, DIAL, LEVER AND TELEMETRY FUNCTION ASSIGNMENTS }

Changing the Switch Mode:

The ON and OFF behavior of each Push-Button Switch can be changed to suit the programmed function and your specific
requirements.
The following Switch Modes are available:
TOGGLE - Press the Push-Button Switch to turn the function ON and press the Push-Button Switch a second time to turn the
function OFF.
PUSH - Press and HOLD the Push-Button Switch to turn the function ON and Release the Push-Button Switch to turn the
function OFF.
1) From within the SWITCH menu, scroll UP or DOWN to highlight the Switch
Number [MODE] you would like to change. Choose from SW1 [MODE], SW2
[MODE] or SW3 [MODE].
2) Press the ENTER key, then scroll UP or DOWN to change the desired Switch
Mode value. Choose from either TOGGLE or PUSH.
MODE setting range is PUSH and TOGGLE. The default setting for SW1 is
TOGGLE and for SW2 and SW3 is PUSH.
3) Repeat step 2 to change any other desired Switch Mode values.

Trim Switch Function Assignments

The Trim Assign function allows you to Assign a multitude of different functions to the five Trim Switches Trm1, Trm2, Trm3, Trm4
and Trm5. This allows you to use the Trim Switches to control those functions while you're driving. In addition, the Trim Resolution
(Step value) and the Direction of Travel (REV) of each Trim Switch can be changed to suit the programmed function and your
specific requirements.
Changing the Trim Switch Function Assignments:
1) From within the SYSTEM menu, scroll UP or DOWN to highlight the ASSIGN
menu.
2) Press the ENTER key to open the ASSIGN menu, then scroll UP or DOWN to
highlight the TRIM menu.
3) Press the ENTER key to open the TRIM menu. TRM1 [FUNCTION] > TRIM
be highlighted.
Telemetry System with Sanwa Synchronized Link Support
will
ST
T
SYSTEM
39