Changing The Minimum Value; Changing The Message Name And Message Pop-Up Behavior - Sanwa M12S SUPER User Manual

M12S SUPER
2.4GHZ FH4T RADIO CONTROL SYSTEM USER'S GUIDE
LOG SETUP MENU { TELEMETRY DISPLAY AND LOGGING OPTIONS }

Changing the Minimum Value:

The Minimum value determines the Minimum Telemetry Parameter Data value that will be displayed on the TELEMETRY screen
TLM1 or TLM2 page and also calibrates the Low Side of the TLM1 or TLM2 Indicator scale on the TELEMETRY screen ALL page.
1) From within the TLM1 or TLM2 menu, scroll UP or DOWN to highlight
MIN > 68ºF (or other value depending on the selected Unit value).
2) Press the ENTER key, then scroll UP or DOWN to choose the desired Minimum
value.
MIN setting range is 0.00 to 254, but will vary depending on the selected Unit value. The default setting is 68.0ºF, 32.0ºC
and 20.0 [ ] Custom.
The Minimum value cannot be set Higher than the Alert value or the Maximum value. If necessary, you may need to
Increase these values prior to Increasing the Minimum value.

Changing the Message Name and Message Pop-Up Behavior:

A custom Message Name can be programmed and the Message Pop-Up behavior can be changed to customize Telemetry 1 or
Telemetry 2 Message Alerts. For example, if you're using a Fuel Level Sensor, you can program a Message that says "Low Fuel"
that will pop up on the LCD screen when the Telemetry Alert Alarm value is reached.
1) From within the TLM1 or TLM2
menu, scroll UP or DOWN to
highlight MESSAGE > [
2) Press the ENTER key to open
the TELEMETRY MESSAGE menu.
3) Using the same methods that you used to change the Model Name, change
the Message Name as desired. For example, HIGH TEMP or LOW FUEL. For
more information, see the Model Name section on pages 29 and 30.
4) From within the TLM1 or TLM2 menu, scroll UP or DOWN to highlight POP-
UP > DEFAULT .
5) Press the ENTER key, then scroll UP or DOWN to choose the desired Telemetry
Alert Pop-Up value.
Three Pop-Up Options are available:
DEFAULT - When selected, a Pop-Up Telemetry Alert that shows the current Telemetry Parameter Data value will be displayed
when the Telemetry Alert value is reached.
MESSAGE - When selected, a Pop-Up Telemetry Alert with your custom Message will be displayed when the Telemetry Alert
value is reached.
OFF - When selected, the Telemetry Alert Pop-Up Message will be turned OFF.
POP-UP setting range is DEFAULT, MESSAGE and OFF. The default setting is DEFAULT.
Telemetry System with Sanwa Synchronized Link Support
] .
T
SYSTEM
63