Auxiliary Dial Function Assignments; Changing The Auxiliary Dial Step Value - Sanwa M12S SUPER User Manual

M12S SUPER
2.4GHZ FH4T RADIO CONTROL SYSTEM USER'S GUIDE
ASSIGN MENU { SWITCH, DIAL, LEVER AND TELEMETRY FUNCTION ASSIGNMENTS }
Changing the Trim Switch Direction of Travel, Continued:
2) Press the ENTER key, then scroll UP or DOWN to change the desired Trim
Switch Reverse value.
REV setting range is NOR and REV. The default setting is NOR.
3) Repeat step 2 to change any other desired Trim Switch Reverse values.

Auxiliary Dial Function Assignments

The Dial Assign function allows you to Assign a multitude of different functions to the Auxiliary Dial. This allows you to use the
Auxiliary Dial to control those functions while you're driving. The Auxiliary Dial can control either of the two Auxiliary channels or it
can control a function, such as Steering Dual Rate or Steering Exponential. In addition, the Trim Resolution (Step value) and the
Direction of Travel (REV) of the Auxiliary Dial can be changed.
Changing the Auxiliary Dial Function Assignment:
1) From within the SYSTEM menu, scroll UP or DOWN to highlight the ASSIGN
menu.
2) Press the ENTER key to open the ASSIGN menu, then scroll UP or DOWN to
highlight the DIAL menu.
3) Press the ENTER key to open the DIAL menu. DIAL [FUNCTION] > AUX1 (or other
value depending on the selected Car Type) will be highlighted.
4) Press the ENTER key, then scroll UP or DOWN to choose the desired function
you want to Assign to the Auxiliary Dial.
The table below shows the default Auxiliary Dial functions based on the selected Car Type.
A complete list of functions that can be Assigned to the Auxiliary Dial are shown in the Trim
Switch, Auxiliary Dial and Auxiliary Lever Functions tables on pages 114 and 115.
Model Type TYP I
AUX1
Function

Changing the Auxiliary Dial Step Value:

The Step function allows you to adjust how far a servo travels or a function moves when the Auxiliary Dial is turned. You can
Increase the Trim Resolution by Decreasing the Step value, so that the amount of travel is less when you turn the Auxiliary Dial.
This makes it possible to fine-tune servo travel or function movement extremely accurately. Alternately, you could Decrease the
Trim Resolution by Increasing the Step value, so that the amount of travel is more when you turn the Auxiliary Dial. This may not
be as accurate, but it allows you to command large amounts of servo travel or function movement at a time.
1) From within the DIAL menu, scroll UP or DOWN to highlight DIAL [STEP] > 5.
2) Press the ENTER key, then scroll UP or DOWN to choose the desired Auxiliary
Dial Step value.
STEP setting range is 1 to 100. The default setting is 5. The Step value is a
percentage of travel.
Telemetry System with Sanwa Synchronized Link Support
TYP II TYP III TYP IV
AUX AUX ---
TYP V TYP VI TYP VII
AUX --- ---
SYSTEM
TYP VIII TYP IX TYP X
AUX AUX ---
T
41