Table of Contents
Advertisement
M12S SUPER
2.4GHZ FH4T RADIO CONTROL SYSTEM USER'S GUIDE
LOG SETUP MENU { DISPLAY ONLY TELEMETRY OPTIONS }
Calibrating the Throttle Output Data Display, Continued:
4) Press the ENTER key. The TH POINT menu will be displayed and NEUTRAL
POINT > 127 will be highlighted.
5) With your other transmitter turned ON and paired with the M12S Super, do the
following:
A) Center the other transmitter's Throttle Trigger, then press the ENTER key
on the M12S Super.
B) Scroll DOWN to highlight HIGH END > 212. Pull and HOLD the other
transmitter's Throttle Trigger all the way BACK, then press the ENTER key
on the M12S Super.
C) Scroll DOWN to highlight BRAKE END > 42. Push and HOLD the other
transmitter's Throttle Trigger all the way FORWARD, then press the ENTER
key on the M12S Super.
The values displayed in the TH POINT fields don't represent actual
Throttle Trigger movement and may vary. Throttle Trigger movement
is displayed as a percentage below the TH POINT fields.
USER NAME MENU { TRANSMITTER USER NAMING }
The User Name function allows you to enter a User Name that is displayed on the STATUS screen, just above the M12S logo.
This allows you to personalize your transmitter by naming it. The User Name can consist of up to 14 letters, numbers or symbols.
Choose from capital letters, Lower case letters, numbers and various symbols.
If the User Name is left blank, the Airtronics or Sanwa logo will be displayed
in its place. The logo displayed will vary based on region.
Entering a User Name:
1) From within the SYSTEM menu, scroll UP or DOWN to highlight the USER
NAME menu.
2) Press the ENTER key to open the USER NAME menu. The underscore will be
positioned under the first space in the User Name. Press the ENTER key a
second time
3) Scroll UP or DOWN and press the SELECT switch RIGHT or LEFT to highlight a
character in the Character List. Press the ENTER key to select the highlighted
character. That character will be displayed in the User Name and the underscore
will advance to the next space. If at any time you can't move the underscore,
press the BACK key to re-gain control of the underscore.
4) Repeat step 3 to enter the rest of the characters. Up to 14 characters can be
entered. If desired, press the BACK key to re-gain control of the underscore,
then use the SELECT switch or scroll UP or DOWN to move the underscore
RIGHT or LEFT. To add a space (or spaces) in your User Name, use the
character.
66
Telemetry System with Sanwa Synchronized Link Support
SYSTEM
SYSTEM
Advertisement
Table of Contents
