Table of Contents
Advertisement
M12S SUPER
2.4GHZ FH4T RADIO CONTROL SYSTEM USER'S GUIDE
LOG SETUP MENU { TELEMETRY DISPLAY AND RECORDING OPTIONS }
Turning Telemetry Data Recording ON and OFF, Continued:
2) Press the ENTER key to open the LOG SETUP menu, then scroll UP or DOWN
to highlight the REC menu.
3) Press the ENTER key to open the REC menu. REC > ON will be highlighted.
4) Scroll UP or DOWN to choose the desired Record value, either ON or OFF.
When set to ON, Telemetry Data will be Recorded. When set to OFF, Telemetry
Data will not be Recorded.
REC setting range is ON or OFF. The default setting is ON.
RPM and Speed Telemetry Data Display Options
The RPM menu allows you to change the way RPM and Speed information is displayed on the TELEMETRY screen ALL and RPM
pages. For example, you can choose to display RPMs, MPH or KM/H. The RPM Gauge and the RPM Digital Display names will
even change from RPM to MPH or KM/H depending on the RPM Unit value chosen. In addition, you can define the Maximum
Telemetry Data values that are displayed and the RPM sensor can be calibrated to ensure that the most accurate RPM or speed
in MPH or KM/H is displayed for your specific model.
Changing the RPM Unit Value:
1) From within the SYSTEM menu, scroll UP or DOWN to highlight the LOG SETUP
menu.
2) Press the ENTER key to open the LOG SETUP menu, then scroll UP or DOWN
to highlight the RPM menu.
3) Press the ENTER key to open the RPM menu. UNIT > RPM will be highlighted.
4) Press the ENTER key, then scroll UP or DOWN to change the RPM Unit to the
desired value. When RPM is chosen, the RPM of whatever the RPM Sensor is
attached to will be displayed. When MPH or KM/H is chosen, the speed of your
model will be displayed in either MPH or KM/H, respectively.
UNIT setting range is RPM, MPH and KM/H. The default setting is RPM.
When you choose UNIT > MPH or UNIT > KM/H the RATIO > value will
be replaced with a 10COUNT DIST. > value.
Changing the Maximum Scale Value:
1) From within the RPM menu, scroll UP or DOWN to highlight the MAX SCALE >
value. This value will vary depending on the UNIT > value chosen previously.
Telemetry System with Sanwa Synchronized Link Support
SYSTEM
Advertisement
Table of Contents
