Table of Contents
Advertisement
M12S SUPER
2.4GHZ FH4T RADIO CONTROL SYSTEM USER'S GUIDE
PC LINK { SAVE TRANSMITTER DATA AND UPDATE FIRMWARE }
Before proceeding, download and save the latest Firmware version to a convenient location on your PC. Updates (when
available) can be downloaded from the M12S Super product page at http://www.airtronics.net. For users outside of North
America, visit the web page of your Sanwa regional distributor or Sanwa directly at http://www.sanwa-denshi.com.
WARNING: The Update process will take approximately 5 to 10 minutes. Make sure that before starting the Update process
that the transmitter's battery voltage is sufficient to complete the Update process. Once started, DO NOT STOP the Update
process and DO NOT unplug the transmitter from your PC!
Updating the Transmitter Firmware Version:
1) From within the SYSTEM menu, scroll UP or DOWN to highlight the PC LINK
menu.
2) Press the ENTER key to open the PC LINK menu, then scroll UP or DOWN to
highlight the UPDATE menu.
3) With the PC LINK Manager 3 software running and the transmitter connected,
press the SOFTWARE UPDATE button on the PC LINK Manager 3 software.
4) Navigate to the folder where you Saved the new Firmware version (.tom file), then select the file and press the Open button. Do
not press the Start button on the PC LINK Manager 3 software yet!
5) Press the ENTER key. PC TRANSMIT UPDATE OK? NO/YES will be displayed.
6) Scroll UP or DOWN to highlight YES, then press the ENTER key. PC START will
be displayed.
If you want to go back or if you don't want to Update the Firmware version
for any reason, choose NO or press the BACK key.
7) Press the Start button on the PC LINK Manager 3 software and allow the Update process to complete. Once completed, The
Operation Was Completed will be displayed on your PC and the transmitter will Reset. Turn the transmitter OFF, unplug the
USB cable from the transmitter, then turn the transmitter back ON to finalize the Update process.
8)
You can view that the Firmware update was successful by checking the new Firmware version in the INFORMATION menu.
INFORMATION MENU { FIRMWARE VERSION, BOOT SCREEN, AND BASIC MODE }
The INFORMATION menu allows you to view the transmitter's current Firmware version, in addition to the transmitter's cumulative
On-Time in Hours and Minutes, and allows you to change the BOOT menu behavior, turn BASIC Mode ON and OFF and change
the direction the Push-Button Scroll Wheel moves the Cursor.
Resetting the On-Time:
Cumulative On-Time will accrue whether the transmitter is turned ON or if only the Display is turned ON using the DISPLAY key.
If Reset to 00:00 after changing or recharging the transmitter batteries, it can be used to determine battery discharge time. The
On-Time is displayed in Hours : Minutes.
1) From within the SYSTEM menu, scroll UP or DOWN to highlight the INFORMATION
menu.
Telemetry System with Sanwa Synchronized Link Support
T
SYSTEM
SYSTEM
71
Advertisement
Table of Contents
