Table of Contents
Advertisement
M12S SUPER
2.4GHZ FH4T RADIO CONTROL SYSTEM USER'S GUIDE
CH-SET MENU { CHANNEL SET MENU }
Adding Programming Menus to the CUSTOM Menu, Continued:
1) Highlight the Programming Menu you would like to add to the CUSTOM
menu. 'C' ENTRY will be displayed in the Message Display Window.
2) Press the SELECT switch in the direction of the arrow (LEFT). A 'C' will be
displayed in the Pointer next to the Menu Name, indicating the Programming
Menu is now added to the CUSTOM menu and CANCEL will now be displayed
in the Message Display Window.
Removing Programming Menus From the CUSTOM Menu:
1) Highlight the Programming Menu you would like to remove from the CUSTOM
menu. 'C' CANCEL will be displayed in the Message Display Window and a
'C' will be displayed in the Pointer next to the Menu Name, indicating the
Programming Menu is part of the CUSTOM menu.
2) Press the SELECT switch in the direction of the arrow (RIGHT). The 'C' will be
removed from the Pointer next to the Menu Name, indicating the Programming
Menu has now been removed from the CUSTOM menu and ENTRY will be
displayed in the Message Display Window.
TROUBLESHOOTING GUIDE
This troubleshooting guide below and on the next few pages can help you diagnose and solve some of the more common problems
that you may encounter with your M12S Super radio control system. If you cannot solve the problem using this troubleshooting
guide, please contact us directly using the information in the Service and Support section on page 3.
PROBLEM
Transmitter does not turn ON
Transmitter will not bind to receiver
Telemetry System with Sanwa Synchronized Link Support
CAUSE
Transmitter batteries installed incorrectly
Battery tray not plugged in
Transmitter batteries are dead
Damage caused by using incorrect
charger or reverse polarity
Modulation Type incorrect
Too much time elapsed after pressing
receiver Bind Button
Attempting to Bind incompatible receiver
Using Electronic Speed control (ESC)
Receiver batteries are dead
Using incorrect Binding procedure
SOLUTION
Reinstall batteries, observing correct polarity
Plug in battery tray
Replace or recharge transmitter batteries
Contact Customer Service
Change Modulation Type to match receiver
Quickly press ENTER key in BIND menu after releasing
receiver Bind Button
Use only Airtronics or Sanwa 2.4GHz FH3, FH4 or FH4T
surface receivers
Disconnect ESC and use dry cell battery for Binding
procedure, then reconnect ESC after Binding
Replace or recharge receiver batteries
Follow Binding procedure carefully
T
CUSTOM
REFERENCE
111
Advertisement
Table of Contents
