Table of Contents
Advertisement
M12S SUPER
2.4GHZ FH4T RADIO CONTROL SYSTEM USER'S GUIDE
OPTIONAL STEERING WHEEL INSTALLATION
An optional larger diameter Steering Wheel is included to best suit the user. Some user's feel that the larger diameter Steering
Wheel makes the Steering operation seem finer.
To install the optional larger diameter Steering Wheel, follow the steps below:
1) Use a 7mm nut driver to remove the Steering Wheel retaining nut, then pull the Steering Wheel straight off.
2) Remove the foam Steering Wheel grip from the Steering Wheel by firmly pulling it straight off.
3) Pull the Steering Wheel adapter hub from the original Steering Wheel then push it into the optional Steering Wheel.
4) Slide the foam grip over the new Steering Wheel, then reinstall the Steering Wheel. Installation is the reverse of removal.
OPTIONAL GRIP INSTALLATION
Two optional grips (one small and one large) are included to best suit the user. Some user's may find that one of these two grips
feels more comfortable than the normal size stock grip.
To install one of the optional grips, follow the steps below:
1) Remove the original grip from the handle by firmly pulling down on the back of the
grip (at the top), then by pulling the grip out along its edges.
2) To install the new grip, align the molded tabs in the grip with the matching slots in the
handle, then firmly push the molded tabs into the slots, working your way around
the grip until the edges of the grip are flush with the handle.
THROTTLE TRIGGER ANGLE ADJUSTMENT
The angle of the Throttle Trigger can be adjusted Right or Left to change the feel of the Throttle Trigger during use. Some users
may prefer the Throttle Trigger straight while some users my prefer the Throttle Trigger angled toward the Right or Left. It all
depends on your personal preference. Two Throttle Trigger adjustment plates are included to fine-tune the angle.
To adjust the Throttle Trigger angle, follow the steps below:
1) Use a Philips head screwdriver to remove the Throttle Trigger mounting screw (A) from
the Left side of the transmitter.
2) Use the tip of a modeling knife to carefully pop the trigger adjustment plate (B) out of the
transmitter.
A - Throttle Trigger Centered
(Stock)
3) Carefully press the desired trigger adjustment plate (B) into the transmitter, making sure to orientate it in the direction you want
to angle the Throttle Trigger, then reinstall and tighten the Throttle Trigger mounting screw (A).
WRIST STRAP ANCHOR INSTALLATION
A wrist strap anchor is included that can be installed onto the transmitter to facilitate the use of a wrist strap (not included).
To install the wrist strap anchor, follow the steps below:
1) Using a 2.5mm hex wrench, remove the wrist strap anchor mounting screw (A)
from the Right side or Left side of the transmitter.
2) Slide the wrist strap anchor into the mounting slot in the back of the transmitter,
then reinstall and tighten the wrist strap anchor mounting screw (A).
When installing the wrist strap anchor, note its orientation. The U-Shaped
groove (B) in the base of the wrist strap anchor should be pointing down.
Telemetry System with Sanwa Synchronized Link Support
B - Throttle Trigger Angled Slightly.
Angle Right or Left Depending on Orientation.
B
C - Throttle Trigger Angled More.
Angle Right or Left Depending on Orientation.
B
T
GENERAL
GENERAL
GENERAL
A
GENERAL
A
13
Advertisement
Table of Contents
