Copying A Model Template - Sanwa M12S SUPER User Manual

M12S SUPER
2.4GHZ FH4T RADIO CONTROL SYSTEM USER'S GUIDE
MODEL MENU { SELECT, NAME, COPY, CLEAR, SORT AND TEMPLATE }

Copying a Model Template:

1) From within the MODEL menu, scroll UP or DOWN to highlight the TEMPLATE
menu.
2) Press the ENTER key to open the TEMPLATE menu. The Template List will be
displayed and the currently Selected Model will be displayed in brackets at the
bottom of the Template List.
3) Scroll UP or DOWN within the Template List to highlight the Model Template you would like to Copy to the currently Selected Model.
When you Copy a Model Template to the Selected Model, that model's Programming Data will be overwritten.
4) Press the ENTER key. TEMPLATE MODEL OK? NO/YES will be displayed.
Scroll UP or DOWN to highlight YES, then press the ENTER key. EXECUTED
will be displayed and all Model Template Programming Data, including the
Template Name, will be copied to the Selected Model.
If you want to go back and choose a different Model Template or you
don't want to Copy the Model Template to the Selected Model for any
reason, choose NO or press the BACK key prior to EXECUTING.
It's not possible to change Model Template Programming Data or the Template Name prior to EXECUTING. However,
you can change the Model Name and Programming Data after copying the Model Template to the Selected Model.
PRO TIP: Using the PC LINK function, new Model Templates can be downloaded from the Internet, saved to your PC, then
Loaded into the TEMPLATE menu. Model Templates can also be saved to your PC for later use or to archive them if you
have more than five Model Templates. In addition, model Programming Data, including the Model Name can be Saved as
a Model Template. This allows you to share Model Templates with other users. For more information, see the Saving Model
Templates section and the Loading Model Templates sections on pages 69 and 70, respectively.
The following two Model Templates are factory-programmed to get you started:
TEMPLATE T01
Model Name
SP-Vortex ZERO
Car Type
I
Aux Type 1
CODE
Aux Type 2 CODE
Code Aux 1 CODE1 F-BR-R>0
CODE2 N-BR-R>0
CODE3 DRV-F>0
CODE4 N-BR-F>20
CODE5 BR-F>0
Code Aux 2
CODE1 BOST-R>0
CODE2 TURBO>0
CODE3 PW-MOD>0
CODE4 CODE4>0
CODE5 CODE5>0
Telemetry System with Sanwa Synchronized Link Support
Full Brake Rate
Drag Brake
Drive Feel
Drag Brake Feel
Brake Feel
Boost
Turbo
Power Mode
TEMPLATE T02
Model Name SP-Vortex D
Car Type I
Aux Type 1 CODE
Aux Type 2
CODE
Code Aux 1
CODE1 TH-RES>0
CODE2 N-BR-R>0
CODE3 DRV-F>0
CODE4 N-BR-F>20
CODE5 BR-F>0
Code Aux 2 CODE1 BOST-R>0
CODE2 RE-LMT>0
CODE3 ACT-TH>0
CODE4 CODE4>0
CODE5 CODE5>0
SYSTEM
Throttle Response
Drag Brake
Drive Feel
Drag Brake Feel
Brake Feel
Boost
Rev Limiter
Active Throttle
33
T