Table of Contents
Advertisement
M12S SUPER
2.4GHZ FH4T RADIO CONTROL SYSTEM USER'S GUIDE
DRIVING POSITION ADJUSTMENT
The position of the Steering Wheel can be switched from the Right side to the Left side to accommodate left-handed drivers. This
makes the M12S Super much more comfortable for natural left-handed drivers to use.
To change the driving position for left-handed use, follow the steps below:
1) Using a 2.5mm hex wrench, remove the three socket cap screws (A) that hold the
Display Switch Cover in place, then carefully pull the Display Switch Cover off.
B
3) Carefully pull the main body up and off the base (C), being careful not to
damage any of the wiring.
4) Rotate the main body 180º (D), then push it back down onto the base
(E), being careful not to pinch any of the wiring.
5) Reinstall the two socket-cap screws you removed previously to secure
the main body to the base.
6) Reinstall the Display Switch Cover. Installation is the reverse of removal.
When reinstalling the Display Switch Cover, make sure to install
the two machine screws into the sides of the cover and the
one self-tapping screw in the top of the cover.
Activating the Left Side Switches:
Two duplicate switches (Sw3 and Trm5) are positioned on the left side
of the transmitter for use in the left-handed driving position. In the default
configuration, these switches are Inhibited for right-handed use. When
you switch the driving position as described above, you will want to Activate these switches for ease of use.
To Activate the Sw3 and Trm5 switches on the Left side of the transmitter, follow the steps below:
1) Remove the grip from the handle by firmly pulling down on the back of the grip (at the top), then
by pulling the grip out along its edges.
2) Flip the switch that's in the back of the handle. When the switch is in the DOWN position,
the left-hand switches will be Active and when the switch is in the UP position, the right-hand
switches will be Active.
3) Reinstall the grip by aligning the molded tabs in the grip with the matching slots in the handle, then
firmly pushing the molded tabs into the slots, working your way around the grip until the edges
of the grip are flush with the handle.
Changing the Programming Cursor Scroll Direction:
When you switch the driving position as described above, the direction the Push-Button Rotary Dial moves the Programming
Cursor will be reversed. If desired, the direction the Push-Button Rotary Dial moves the Programming Cursor can be changed.
The direction the Push-Button Rotary Dial moves the Programming Cursor is changed in the INFORMATION > KEY menu. For more
information, see the changing the Changing the Programming Cursor Scroll Direction section on page 72.
16
Telemetry System with Sanwa Synchronized Link Support
B
2) Using a 2.5mm hex wrench, remove the two socket-cap screws
(B) from the bottom the transmitter that hold the main body in
place.
GENERAL
A
A
D
E
C
A
Advertisement
Table of Contents
