Table of Contents
Advertisement
Usage of each feature
TRIM
● For Trim, you can adjust Trim for each channel and set the Trim action (center/parallel).
TRIM
●Correct neutral (center) of each channel (ST/TH/AUX1/AUX2) with Trim.
●As default, steering is set for Trim 1 (TRM1), and throttle for Trim 2 (TRM2).
1) Select a channel (ST/TH/AUX1/AUX2) for adjusting
Trim with the Select button.
2) Determine with Enter operation and adjust with the
multi-selector.
○Setting range: ST ： L100～R100
○Default: ST ： 0
TH ： 0
AUX1： 0
AUX2： 0
*Make an adjustment with TRM1 (ST) and TRM2 (TH)
during operation. You can change the Trim lever position
with the Key Assignments Trim feature (P. 52).
●About Trim
Important
Trim is a feature to adjust the neutral (center) position of the servos.
After installing the steering servo onto a car, you can adjust with Trim when the car does not move straightly.
Neutral position adjustment is necessary not only after installing the servo but for changes that happen during
running such as tire wears and chassis twist.
●Itʼs Sub Trim that adjusts het center position when adjusting linkage (P. 26)
● If Trim and Sub Trim are off to one side, it causes dead band (the range the servo does not move) to the steering wheel and the
throttle trigger. When installing the servo horn, fix the servo horn as close to the center as possible and center it with Sub Trim.
Note
TRIM TYPE
●You can set Trim performance of each channel to Center Trim (CENT) and Parallel (PARA).
●As default, steering is set for Trim 1 (TRM1), and throttle for Trim 2 (TRM2).
1) Select a channel (ST/TH/AUX1/AUX2) to set with the Select button.
2) Determine with Enter operation and adjust with the multi-selector.
○Setting range: CENT (Center Trim)/PARA (Parallel Trim)
○Default:
●About Center Trim and Parallel Trim
Important
There are two types of Trim including Center Trim that adjusts only the neutral position without changing the end of the operating
angle and Parallel Trim that moves the end of the operating angle and the neutral position simultaneously. Sub Trim that adjusts
the neutral (center) position before fixing the servo horn is Parallel Trim and the main trim has options of Center Trim and Parallel Trim.
You can select according to your purpose.
○Center Trim
２９
TH ： H100～B100
AUX1 ： H100～L100
AUX2 ： H100～L100
CENT (Center Trim)
Even if you move the neutral
position with Trim, the end of the
operation angle does not move.
SETTING
Selecting a channel with the Select button
Trim 2
(TRM 2)
Selecting a channel with the Select button
○Parallel Trim
When you move the neutral position with Trim,
the end of the operation angle also moves.
When Sub Trim is adjusted after linkage is completed,
readjustment of End Point Adjustment (EPA) will be
necessary.
Trim 1
(TRM 1)
Advertisement
Table of Contents
