Key Assign Switch - Sanwa MT-44 Manual

Usage of each feature
SYSTEM MENU
●A feature for setting system of the transmitter, such as BIND, KEY ASSIGN, BUZZER, BATTERY, LCD
and VR ADJUST (Volume adjustment).
Positions of the Switch and Trim
TRIM 2
TRIM 4
SWITCH 2
KEY ASSIGN SWITCH [KEY ASSIGN SW]
●You can assign features to the switches (SW1, SW2, SW3) of the transmitter
and toggle ON/OFF of the features during operation.
1)Select [SYSTEM] with the multi-selector and determine
with the Enter operation.
2)Select [KEY ASSIGN] with the multi-selector and
determine with the Enter operation.
3)Setting the Switch (SW1/SW2)
Operate the Enter with [SW] and set the feature to
assign to the switch with Up key/Down key.
○Setting range:
SWITCH
OFF、ASIST-ST、D/R-ST、D/R-TH、D/R-BR、CUR-ST、CUR-TH、
SW1
SPD-ST、SPD-TH、ALB、OFFSET、AUX1、AUX2、TIMER、TE-CLR、
SW2
LOGGER、R-MODE
○Default : SW1: TIMER
*BY Setting [ASSIST-ST] onto SW1/SW2,
you can turn ON/OFF the feature of D/R, SPEED
and CURVE that can be set onto the steering.
4)Setting Mode
It sets the switch performance but there are cases
that youcannot set depending on the feature to assign.
○Setting range:
TOGGLE (Switching between ON/OFF when pressed every time )
PUSH (ON only during being pressed)
５１
TRIM 1
PUCH SWITCH 1
An assignable feature
SW2: OFF
Features assgined to the Switch and
Trim at the factory
TR1：Steering Trim(TRM-ST)
TR2：Throttle Trim(TRM-TH)
TR3：Dual Rate ST(D/R-ST)
TR4：Dual Rate BR(D/R-BR)
SW1 ：Timer (TIMER)
SW2 ：CUSTOM
DIAL
TRM 3
SYSTEM
ENTER BACK
ENTER BACK