Table of Contents
Advertisement
Usage of each feature
System Menu
●A feature for setting system of the transmitter, such as Bind (BIND), Key Assignments
(KEY ASSIGN), BUZZER (Buzzer), Battery (BATTERY), LCD and CALIBRATION (Calibration).
[BIND]
●Select the output system that suits the receiver, set a mode for the servo (analog/digital) and
the speed controller to be used and bind the transmitter with the receiver.
1)Select [SYSTEM] with the multi-selector and determine
with the Enter operation.
2)Select [BIND] with the multi-selector and determine
with the Enter operation.
3)Setting RF MODE (RE MODE: Signal output system)
Set the output system with the multi-selector.
○ Output System
・FH4T
RX-482, RX-481, RX-472, RX-471, RX-47T
RX-462, RX-461, Mode for SV-PLUS series
・FH3
RX-451R, RX-451, RX-381, Mode for RX-380
○Output System
*When changing the output system, a message is displayed
on the screen. Follow the display to operate.
4)Setting TELEMETRY
Set TELEMETRY with the multi-selector.
Setting range: ON/OFF
○Default :
*Telemetry Compatible Equipment
・ RX-482、 RX-472、 RX-47T、 RX-462、 RX-461、 SV-PLUS series
*Re-BIND is not necessary even if setting is changed.
5)Setting SAFETY LINK
Set SAFETY LINK (Safety Link) with the multi-selector.
○ Setting range: 01 ~ 50
○ Default :
*When changing the setting of SAFETY LINK after BINDING, BIND again.
Output System
Supplement
●A feature for preventing runaway due to an error of Model Select. You can set a Link No. for each Model
●When performing Model Copy (FULL), the Link No. is also copied.
●Default is set to [01]. When Link No. is not being changed, receivers that are BINDED will be working for all models
●Safety Link works only for [FH4T].
４９
Confirmation Screen
ON
01
SYSTEM
ENTER
BACK
ENTER
BACK
Output System
Response Mode
Advertisement
Table of Contents
