Maple Systems Silver Plus Series Installation And Operation Manual page 99

Cre ating Your First Project
8 Select COM port and PLC station number (see Controller information Sheet for your PLC)
and then click Settings... The COM Port Setting dialog appears.
9. Select the appropriate COM port..
10. Select baud rate, parity, data bits, and stop bits. Use Maple Systems' Controller Information
Sheets or the PLC manufacturer's operations manual for information on the communications
parameters required by the PLC. These parameters have to match the PLC settings.
11. Click OK.
12. Interval of Block Pack (Words): Determines how many words are read from the PLC in
one communication cycle. For more information on this feature, see PLC Block Pack at the
end of this chapter.
13. Click OK.
95
1010-1007, Rev 05