The Moving Shape Ob Ject - Maple Systems Silver Plus Series Installation And Operation Manual

194
3. In the Read address frame, select the device type from the drop down menu and then specify
the PLC register address that the part continuously reads. Select No. of words: Remember, 1
word = 2 characters.
4. In the Notification frame, check the Enable box if the OIT is to notify the PLC when the
object has been activated. Configure whether the specified bit is to be turned on or off,
whether the bit is to be written before or after the data is written, and finally specify the PLC
Coil that the OIT is to write to.
5. In the Keyboard section, select your kepyad from the drop-down menu, and then select the
popup position relative to the OIT screen using the nine-dot matrix indicated (for instance,
clicking the middle dot will pop the keypad up in the middle of the display).
6. Click the Security tab to display the security form.
7. To enable security for the object, click the Enable checkbox and configure PLC settings from
the drop-down menu.
8. Select the level of user restriction from the Object class drop-down menu.
9. You may select to make the object invisible while protected. You may also wish to enable a
sound that plays when the protection keypad popus up. Sounds can be selected from sound
libraries.
10. Click the Shape tab to configure a shape or bitmap that is displayed behind the number.
11. Click the Font tab to configure the font.

The Moving Shape Ob ject

The Moving Shape Object performs three functions depending upon the values in three consecutive PLC registers:
• Similar to the Word Lamp Object, the Moving Shape object continuously reads a PLC register and
displays the corresponding shape or bitmap that is tagged to the number of states defined.
1010-1007, Rev 05
Sil ver Plus Se ries In stal la tion & Op er a tion Man ual