Table of Contents
Advertisement
198
An offset may be optionally used at (Control Word + 2), to indicate a different starting location for the data. The
specified value is the offset from the specified Control Word.
Description
No. of Channel
Cursor Line
Enable
Color
PLC Name
Device Type
Address
Channel
PLC Name
1010-1007, Rev 05
Enter a name for the object. This isn't necessary, but will help in later identification of the object.
Specify the number of sets of data to plot.
When enabled, a vertical line will appear on the plot to select a particular location. As the line is
moved, the value(s) at that location is/are loaded into the specified register. The specified register
contains the index of the selected data point (0,1, 2, 3, etc). The next register contains the data
value for that point. If multiple plots are displayed, the values from those plots are loaded into the
next consecutive registers.
Specify the color of the Cursor Line. Available only when the Enable box is checked.
Select the configured PLC to in which to store the Cursor Line data
Specify the register/storage type in which to store the Cursor Line data.
Specify the location in which to store the Cursor Line data.
Select the channel to configure below. Each of the following fields can be unique for each channel.
Select the configured PLC from which to retrieve the data to plot.
Sil ver Plus Se ries In stal la tion & Op er a tion Man ual
Advertisement
Table of Contents
