Maple Systems Silver Plus Series Installation And Operation Manual page 207

Cre ating Your First Project
Trigger Value
1
2
3
Check the User defined tag checkbox if you wish to fill the Device list with Tag Names
instead of using the PLC's Device types. Set No. of Data Address to indicate the address
(offset from the Control Address) that contains the number of data points to plot .
• Select the channel to configure.
• In the Read Address section, select the PLC Name. Check the Separate Addresses for X and Y
Data checkbox if you wish the XY Plot to use separate sets of addresses for X and Y data. If
unchecked, all data is read from the same set of addresses. The current Read Address settings are
displayed in the Read Address box. Click Settings... to reconfigure.
• In the Limits section, check the Dynamic Limits checkbox if you wish the high and low limits to
be read from the controller register. Otherwise, specify the limits by completing the X-axis high
limit, X-axis low limit, Y-axis high limit and Y-axis low limit.
The current data is plotted, any existing plot data remains.
All plotted data is cleared.
The plot is cleared, then the current data is plotted.
Effect
1010-1007, Rev 05
203