Maple Systems Silver Plus Series Installation And Operation Manual page 203

Cre ating Your First Project
Device Type
Control Word Address
Offset to Start Address
No. of Data Address
Data Storage Start
Format
Limit
Min
Max
Data Samples
Sample to Scroll
Enable Scroll Switch
Profile Color
Transparent
Frame
Select the register/storage type from which to retrieve the data to plot.
Specify the location of the graph's control address. The following values may be used:
1: Draws the graph, leaves existing data.
2: Clears the graph.
3: Clears the graph, then redraws with the current data.
After the operation is complete, the Control Word Address will be reset to 0.
When checked, the location (Control Word + 2) will contain a value indicating the starting address
of the data, offset from the address specified for the Control Word. For example, if the Control
Word address is set to 0, and the offset is set to 10, the data will start at address 10.
Read Only. Indicates the address that will contain the number of points to plot.
Read Only. Indicates the address that will contain the first of the data points to plot. If Offset to
Start Address is checked, this indicates the location of the offset value.
Specify the format of the data to graph. Each channel may have a different format.
Specify the value at which the plotted line will be at the bottom of the graph.
Specify the value at which the plotted line will be at the top of the graph.
Specify the number of points to display on each page.
Specify the number of points to move each time a Scroll Button is pressed.
When checked, the Scroll Buttons are displayed.
If checked, the Data Block Display is created without a background color.
Select the color of the border of the Data Block Display. Available only when Transparent is
unchecked.
199
1010-1007, Rev 05