Con Fig U Ra Tion Wir Ing; Con Nect The Oit To The Pc For Con Fig U Ra Tion - Maple Systems Silver Plus Series Installation And Operation Manual

In stal la tion of OITs
STEPS:
1. Prepare the four screw clamps for the HMI5056/5070/5080 or the six screw clamps for the
HMI5104/5121/5150 by positioning the metal brackets at the midpoints of the screws. Position the screws
so that the ends don't protrude from the plastic portions.
2. Set the OIT in the panel cutout and hold it in place until all clamps are in position.
3. Tighten the screw clamps until all are uniformly snug.
CAUTION: Do not over-tighten the screws beyond snugness, or you may damage the housing.
REINSTALLATION: Because the gasket will take a "set" to the panel, be sure to reinstall the OIT to the same
panel cutout when a NEMA 4 seal is required. For best results, also replace the gasket itself.

Con fig u ra tion Wir ing

The OIT must be configured for a particular protocol before use. The EZware-5000 software (used on a PC with
Windows XP, 2000 or Vista) is used for configuring the OIT. For detailed instructions on installing and using the
software, please refer to the software documentation section of this manual.

Con nect the OIT to the PC for Con fig u ra tion

To configure the OIT using Maple System's configuration software, you will need an Ethernet crossover cable,
Maple P/N 7431-0102. If using a switch or router between the PC and the OIT, use a straight-through or crossover
cable as required by the switch or router.
Position screw clamps 6 places in slots provided:
2 screw clamps each side and one top and bottom
If an Ethernet port is not available on the PC, you may be able to install a USB
Ethernet adapter. You can also transfer the project to the OIT with a Compact Flash or
USB memory device. Refer to Chapter 2, OIT Local Setup.
Panel
Side View
15
1010-1007, Rev 05