Maple Systems Silver Plus Series Installation And Operation Manual page 89

Using EZware-5000
option on the Editor tab of the System Parameters dialog. A setting of Control is the default, and sets the behavior
as outlined above. A setting of Nature will result in the object remaining at the layer assigned during development.
The Part Layout setting is global, and affects all PLC-controlled objects in the application.
Nudg ing Ob jects
Nudging is used to fine-tune the movement of objects in the work area of EasyBuilder. Using the nudge feature on
a selected object will move that object in the specified direction either by one pixel or by the grid setting amount.
Using the nudge top
1. Select one of the layered objects or a group of objects in the work area of EasyBuilder.
2. From the Edit menu, click Nudge, then select the direction of the nudge or click the
appropriate icon from the Manager toolbar.
Aligning Ob jects
Alignment can be used to quickly align two or more objects. Aligning justifies objects to the desired position of the
last-selected object. The last select object will have "handles" of a different color than the other selected objects. To
better illustrate, refer to the left side of Window_12 of the sample project:
Using the align left
1. Select the objects you wish to align. For this example, select the three rectangle objects of
Window_12.
, bottom , left
command
, and right commands
85
1010-1007, Rev 05