Table of Contents
Advertisement
124
Using the Fast Se lec tion Key
The fast selection key is used to display the Fast Selection window. Pressing the key again causes the Fast Selection
window to close.
Cre at ing the Fast Se lec tion Key
The fast selection key must be activated in System Parameters in order to have it display on the OIT. The fast
selection key will always display on the operator interface.
To display the fast selection key
1. Select Edit-System Parameters. The System Parameters Setting Dialog appears. Select the
General tab.
2. In the Fast selection button section, select Enable from the Attribute drop down menu.
3. Select either right or left from the Position drop down menu to select whether the button will
appear in the right lower corner or left lower corner of the display.
4. Click Settings... Click the Use shape checkbox, and then select Shape Library...
5. Select a shape for your fast selection button and click OK.
1010-1007, Rev 05
Sil ver Plus Se ries In stal la tion & Op er a tion Man ual
Advertisement
Table of Contents
