Table of Contents
Advertisement
Cre ating Your First Project
2. Click Compile. EasyBuilder will compile your project and display error results.
3. If no errors occur, click Close. The main screen of EasyBuilder reappears. If errors have
occurred, repeat the steps in the Creating a Sample Project section.
Downloading your first project
It is necessary to determine the IP Address of the OIT. By default, the OIT is configured to get a dynamic IP
address from a DHCP server. This setting can be changed, To determine or change the OIT's IP address:
1. Plug a USB mouse into the OIT.
2. Apply power to the OIT.
3. Move the mouse pointer to the lower right corner of the OIT screen. A menu bar will appear,
Click the wrench icon on the left side of the bar.
4. On the Network tab of the System Settings dialog, the OIT's IP address will be shown. If set
for Auto Get IP Address, the OIT's current IP setup information is displayed but is not
changeable. To change the IP address, select IP Address Get From Below and enter the data.
5. Once the IP Address has been established, the project can be downloaded. From
EasyBuilder's Tools menu, select Download. Or, click the Download icon.
6. Enter the OIT's IP address and Download password. The default download password is
111111. The default address is 192.168.
7. Make sure that the Firmware and Reboot HMI After Download boxes are checked.
8. Click the Download button. If the OIT is properly connected to the PC, the status box on the
download dialog will update with messages indicating the progress of the transfer. The OIT
itself will also display messages reflecting its status.
9. When the download is complete, the OIT will restart. Click the Exit button on the Download
dialog.
CONGRATULATIONS. You have completed your first EZware-5000 project.
0.201,
Subnet 255....0, Gateway 192.168.0.254.
57
1010-1007, Rev 05
Advertisement
Table of Contents
