Table of Contents
Advertisement
Cre ating Your First Project
4. Using the keypad, enter digits 1, 2, 3, 4, and 5. As you enter the digits, each one should
appear in the Numeric Input Object box.
5. Press the Backspace key to delete digit 5.
6. Try pressing any of the alpha characters (A-Z). Notice that alpha characters are not accepted
into a Numeric Input Object register.
7. Press the Clear key. Notice that the entire register is cleared to 0.
8. Enter digits 5, 4, 3, 2, 1, and then press the Enter key. The keypad closes but the value was
not accepted. This indicates that the value entered is out-of-range. Touch the numeric input
object again. Press the Clear key and enter 32767. Press the Enter key. Notice that this
value is accepted and blinking stops.
9. Touch the Numeric Input Object register again to activate editing mode. Enter five more
digits then press the Esc key. Notice that the entry is cancelled and the previous number
32767 is restored.
10. Change the value of the ASCII Input register. Touch the ASCII Input Object to activate
the edit mode.
11. Using the keypad, enter the character string "HELLO WORLD". As you enter the characters,
each one should appear in the ASCII Input Object box. Press the Enter key to send the
characters to the OIT internal data register.
211
1010-1007, Rev 05
Advertisement
Table of Contents
