Rep Re Senting Plc Data Reg Is Ters; The Word Lamp Ob Ject - Maple Systems Silver Plus Series Installation And Operation Manual

176
Momentary
6. Refer to the Bit Lamp Object section for information on using the Shape tab
7. Refer to the Bit Lamp Object section for information on using the Label tab.
8. Click OK. The Create Toggle Switch Object form closes and the main screen of EasyBuilder
appears with the cursor tied to a rectangular outline of the part you just created at the upper
left corner of the screen. Move the part to the desired location in the window.
9. Once the part is placed onto the window, you can adjust the location of the label inside the
part by clicking once on the label. This will highlight the entire object. Now click on the
label again. Now only the label is highlighted, allowing you to move it without moving the
part. Note: if you double-click (click twice rapidly) then you will not highlight the label but
rather enter the Toggle Switch Object's Attribute dialog box.

Rep re senting PLC Data Reg is ters

PLC registers and internal data registers of the OIT are represented using nine parts:
• Word Lamp Object
• Set Word Object
• Multistate Switch Object
• Numeric Display Object
• Numeric Input Extend Object
• ASCII Data Object
• ASCII Input Extend Object
• Moving Shape Object
• Animation Object
They are constructed in much the same manner as the parts described in the previous section. With these parts,
however, you can represent data from 16-bit, 32-bit, or even 64-bit data registers.

The Word Lamp Ob ject

The Word Lamp Object is used to represent the value of a PLC register. The object continuously reads the PLC
register and displays the corresponding shape or bitmap that is tagged to the number of states defined.
1010-1007, Rev 05
Sets a PLC coil when pressed; clears a PLC coil when released
Sil ver Plus Se ries In stal la tion & Op er a tion Man ual