List Of Fea Tures - Maple Systems Silver Plus Series Installation And Operation Manual

Introduction

List of Fea tures

The next chapter will guide you through the creation of your first project. Before you proceed, you may wish to read this
brief list of some of the features offered in the Silver Plus Series OIT.
Icon Name
Bit Lamp
Word Lamp
Set Bit
Set Word
Toggle Switch
Slider Object
Multi-State
Switch
Function Key
Numeric Input
Numeric Data
ASCII Input
ASCII Data
Moving Shapes
Animation
Indirect Window
Direct Window
Alarm Displays
Alarm Bar
Description
Creates a graphics object to reflect the current status of a PLC bit.
Creates a graphics object to reflect the current state of a multi-state PLC data register.
Creates a touchscreen graphics object that represents a two-state switch. When pressed it
sets/resets a PLC bit.
Creates a touchscreen graphics object that represents a multi-state switch. When pressed it can
place a constant value in a PLC register or jog the value.
Creates a touchscreen graphics object that represents a two-state switch changing state
(picture) based upon a PLC bit. When pressed, it can control another PLC bit.
Creates a touchscreen graphics object that changes the state according to the position of a
slider switch.
Creates a multi-state touchscreen graphics object that changes state (picture) according to the
value in a PLC data register. When pressed, it sends a value(s) to another PLC register.
Creates a touchscreen graphics object or runs a macro.
Displays a number stored in a PLC register. The number can be changed using a numeric
keypad.
Displays a number stored in a PLC register.
Displays ASCII characters stored in a PLC register. Characters can be changed using an
alphanumeric keypad.
Displays ASCII characters stored in a PLC register.
Creates a multi-state graphics object, which changes state (picture) and position on the screen
according to a value in a PLC register.
Creates a multi-state graphics object, which changes state (picture) on the screen according to a
value in a PLC register. The positions on the screen are predefined.
Configures the OIT to monitor PLC data registers to display for a specific window popup by a
PLC word address
Displays a Window based on a bit in a PLC register.
Creates alarms to display alarms sent from the Alarm/Event Log Object.
Displays alarms detected by the Alarm/Event Log Object on a single horizontal scrolling line.
5
1010-1007, Rev 05