xStack® DES-3200 Series Layer 2 Ethernet Managed Switch CLI Reference Manual
The Gratuitous ARP commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in the
following table.
Command
config gratuitous_arp send
ipif_status_up
config gratuitous_arp send
dup_ip_detected
config gratuitous_arp learning
enable gratuitous_arp
disable gratuitous_arp
config gratuitous_arp send
periodically ipif
show gratuitous_arp
Each command is listed, in detail, in the following sections.
config gratuitous_arp send ipif_status_up
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To enable a gratuitous ARP request:
DES-3200-28:4#config gratuitous_arp send ipif_status_up enable
Command: config gratuitous_arp send ipif_status_up enable
Success.
DES-3200-28:4#
Parameters
[enable | disable]
[enable | disable]
[enable | disable]
{ipif <ipif_name 12>} {trap | log} (1)
{ipif <ipif_name 12>} {trap | log} (1)
<ipif_name 12> interval <value 0-65535>
{ipif <ipif_name 12>}
Used to enable or disable the sending of gratuitous ARP requests while
the IP interface status is up.
config gratuitous_arp send ipif_status_up [enable | disable]
The command is used to enable or disable the sending of gratuitous ARP
request packets while the IPIF interface is up. This is used to
automatically announce the interface's IP address to other nodes. By
default, the state is enabled, and only one gratuitous ARP packet will be
broadcast.
enable Enable the sending of gratuitous ARP when the IPIF status is
up.
disable Disable the sending of gratuitous ARP when the IPIF status is
up.
Only Administrator-level users can issue this command.
G
RATUITOUS
314
37
ARP C
OMMANDS