Replacing The Power Paddle Module - Lenovo System x3650 M5 Installation And Service Manual

Handle
Figure 84. Power paddle module removal
Step 6. If you are instructed to return the power paddle module, follow all packaging instructions, and use
any packaging materials for shipping that are supplied to you.

Replacing the power paddle module

Use this information to install the power paddle module.
To install the power paddle module, complete the following steps:
Step 1. Read the safety information that begins on "Safety" on page v and "Installation guidelines" on page
305.
Step 2. Turn off the server and peripheral devices and disconnect the power cords and all external cables,
if necessary.
Step 3. Remove the top cover (see "Removing the top cover" on page 162).
Step 4. Grasp the handle and align the power paddle module with the connector on the system board.
Push the power paddle module to the system board and make sure it is firmly seated.
168
Lenovo System x3650 M5 Installation and Service Guide
Power paddle assembly