Table of Contents
Advertisement
Step 4.
Install the hard disk drive in the drive bay:
a.
Grasp the black drive handle and slide the blue release latch to the right and align the drive
assembly with the guide rails in the bay.
Figure 43. Simple-swap hard disk drive installation
b.
Gently push the drive assembly into the bay until the drive stops.
Step 5.
Reinstall the drive bay filler panel that you removed earlier.
Step 6.
If you are installing additional simple-swap hard disk drives, do so now.
Step 7.
Turn on the peripheral devices and the server.
IDs for simple-swap hard disk drives
The simple-swap-drive ID that is assigned to each drive is printed on the front of the server.
The following illustration shows the location of the IDs of the hard disk drives. The ID numbers and the drive
bay numbers are the same.
Figure 44. Simple-swap hard disk drive IDs
Removing an optional DVD drive
Use this information to remove an optional DVD drive.
To remove an optional DVD drive, complete the following steps:
Step 1.
Read the safety information that begins on
417.
Step 2.
Turn off the server and peripheral devices and disconnect all power cords.
Step 3.
Remove the cover (see
Step 4.
Press and hold the release tab down as you push the drive from the rear to slide it out of the bay.
"Safety" on page v
"Removing the cover" on page
and
"Installation guidelines" on page
424).
.
Chapter 5
Removing and replacing components
441
Advertisement
Table of Contents
