Table of Contents
Advertisement
Step 2.
If you removed an expansion unit from the blade server, install it now (see "Installing an optional
expansion unit" on page 59).
Step 3.
Lower the cover so that the slots at the rear slide down onto the pins at the rear of the blade server,
as shown in the illustration. Before you close the cover, make sure that all components are installed
and seated correctly and that you have not left loose tools or parts inside the blade server.
Blade server
cover
Cover
pins
Step 4.
Pivot the cover to the closed position until it clicks into place.
Step 5.
Install the blade server into the BladeCenter unit (see "Installing the blade server in a BladeCenter
unit" on page 39).
Removing the bezel assembly
Use this information to remove the bezel assembly from the blade server.
The following illustration shows how to remove a bezel assembly from a blade server.
Note: The illustrations in this document might differ slightly from your hardware.
74
BladeCenter HS23 Blade ServerProblem Determination and Service Guide
Blade server
cover release
Blade server cover
release
Advertisement
Table of Contents
