Table of Contents
Advertisement
Figure 33. PCI riser filler installation
Step 3.
Reinstall the cover (see "Installing the compute node cover" on page 115).
Step 4.
Slide the compute node into the rack.
Step 5.
Reconnect the power cords and any cables that you removed.
Step 6.
Turn on the peripheral devices and the compute node.
Removing the bezel
Use this information to remove the bezel.
Before you remove the bezel, complete the following steps:
1. Read "Safety" on page v and "Installation guidelines" on page 101.
2. If the compute node is installed in a NeXtScale n1200 Enclosure, remove it (see "Removing a compute
node from a chassis" on page 104 for instructions).
3. Carefully lay the compute node on a flat, static-protective surface, orienting the compute node with
the bezel pointing toward you.
To remove the bezel, complete the following steps:
Step 1.
Remove the cover (see "Removing the compute node cover" on page 113).
Step 2.
Remove the two hex screws by hex screwdriver.
120
Lenovo NeXtScale nx360 M5 Installation and Service Guide
Advertisement
Table of Contents
Troubleshooting
