ZH
ASSEMBLY
CAUTION: If the cross or bearing cap are not
straight during assembly, the bearing cap will
score the walls of the yoke bore and damage can
occur.
1. Apply Extreme Pressure (EP) N.L.G.I. Grade 1 or 2
grease to the inside of the yoke bores.
2. Position the universal joint (1) in the yoke (2) with
its grease fitting, if equipped, pointing up.
3. Place a bearing cap (1) over the trunnion (2) and
align the cap with the yoke bore. Keep the needle
bearings upright in the bearing cap.
PROPELLER SHAFT 3 - 37