Centering And Fitted Sleeves; Removal; Removal - Centering Sleeves - Chrysler 2005 Crossfire SRT6 Service Manual

3 - 38 PROPELLER SHAFT
4. Press the bearing cap into the yoke bore enough to
clear the snap ring groove.
5. Install a snap ring (1).
Note: If the joint is stiff or binding, strike the yoke
with a soft hammer to seat the needle bearings.
6. Repeat the procedure to install the opposite bear-
ing cap.
7. Add grease to the grease fitting, if equipped.
8. Install the propeller shaft. (Refer to 3 - DIFFEREN-
TIAL & DRIVELINE/PROPELLER
INSTALLATION).

CENTERING AND FITTED SLEEVES

REMOVAL

REMOVAL - CENTERING SLEEVES

1. Remove the propeller shaft. (Refer to 3 - DIFFER-
ENTIAL & DRIVELINE/PROPELLER SHAFT -
REMOVAL).
2. Mark the flexible disk (4) relative to the flange (2).
3. Remove the flexible disk (4) from the flange (2).
4. Remove the centering sleeve (3).
SHAFT -
ZH