Installation - Chrysler 2005 Crossfire SRT6 Service Manual

ZH
CAUTION: When removing the halfshaft assembly,
do not allow the snap ring to drag across the seal-
ing lip of the differential oil seal.
6. Carefully pull the halfshaft (1) out of the differential
housing, and remove the halfshaft from the vehicle.

INSTALLATION

1. Thoroughly clean the spline and oil sealing surface
of the halfshaft.
2. Lightly lubricate the oil seal sealing surface of the
halfshaft with clean lubricant.
3. Insert the halfshaft (1) outer end through the wheel
hub.
4. Install the halfshaft into the differential side gear as
far as possible by hand.
5. Forcefully push the halfshaft into the differential
side gear until the snap ring is engaged with the
differential side gear.
Note: Grasp the halfshaft and test the snap ring
and ensure it is fully engaged with the side gear.
HALFSHAFTS 3 - 5