Propeller Shaft - Chrysler 2005 Crossfire SRT6 Service Manual

3 - 28

PROPELLER SHAFT

8. Mark and number the propeller shaft six inches from the transmission end at four positions 90° apart.
9. Run and accelerate the vehicle until vibration occurs. Note the intensity and speed the vibration occurred. Stop
the engine.
10. Install a screw clamp (1) at position 1.
11. Start the engine and re-check for vibration. If there
is little or no change in vibration, move the clamp
to one of the other three positions. Repeat the
vibration test.
12. If there is no difference in vibration at the other
positions, the source of the vibration may not be
the propeller shaft.
13. If the vibration decreased, install a second clamp
and repeat the test.
ZH